Features
Features & Benefits:
High Brightness
Our LED SMD T8 T10 T12 Fluorescent Light Tube consists of high quality LEDs and can emit a higher brightness at much lower cost.
Easy Installation
Our LED SMD T8 T10 T12 Fluorescent Light can be easily installed like a conventional T8/T12 fluorescent light into the existing sockets.
Extended Life
With very little heat output, proper drive characteristics and high quality LEDs, our LED T8 T10 T12 Fluorescent Light Tube has a lifetime of up to 100,000 hours.
The LED T8 Tube is manufactured under ROHS, contains no MERCURY, Emits NO RF interference!!
Humidity/Moisture Resistant
With IP54 degree protection, our LED T8 T10 T12 Tube Light can operate normally even in a moist indoor environment.
Energy Saving!
Our LED T8 Fluorescent Lights consume power from 8W to 36W. This saves much more energy than conventional fluorescent T8 T10 T12 light tubes.
The 8 Foot LED T8 T10 T12 Fluorescent Light Tube is completely enclosed. The LEDs are surrounded by a Frosted acrylic lens and emit light like a conventional T-series fluorescent light. Our LED T8 T10 T12 Tube is typically used for lighting in Garages, Basements, Task Lighting, Store Displays, General Warehouse Lighting, RVs, Buses, and Under Cabinets, Storage Facilities, Generator Powered Remote Sites, Cold Storage, Solar Installations and more. It can be used anywhere you have a T8/T12 series fixture!
Available in four different color temperature renderings:
Warm White: 3700 Kelvin; ~ 3400 lumens - Yellowish Light Natural White: 4100 Kelvin; ~ 3450 lumens - Pinkish Light
Pure White: 6500 Kelvin; ~ 3500 lumens - Pure White Light
Aluminum heat sink, 580 SMD LED's, available in Warm White, or Pure White, No UV or RF interference, Patented heat sink and optical diffuser, longer life than incandescent & fluorescent . No mercury, no ballast required, wide voltage and constant current design, solid state, high shock & vibration resistant, Mercury free, 50%+ savings in energy consumption, quite, no noise, no flickering, This product is MET/CE Approved. The products are also in accordance with CE and FCC testing standards and made to ROHS Standards. Retro-fit kits available for direct replacement of fluorescent fixtures.
We strongly recommend that a qualified individual remove any ballasts and starters to achieve full energy savings.
** Removal of the ballast and started in the fixture are required. Please see our product support section for important information and details on removing the ballast in your fixtures.
|
